Description
David ClarkH10-20 Standard Headset
The “Standard” among noise attenuating headsets.
- Universal flex boom with M-7A microphone.
- Certified 24 dB Noise Reduction Rating.
- Soft foam/Air-Flow pillow headpad.
- Flo-fit gel ear seals.
- Volume control.
- 5-Year Factory Warranty.
Related products
David Clark ONE-X Hybrid ENC Headset
$876.00
- Ear coupling: Around-the-ear (Circumaural)
- Hardware: Lightweight Alloy
- Connector Type: Standard dual GA plugs or 6-Pin Redel Plug for panel DC Power & intercom connections
- Connection Cable: 0.155” (4-mm) OD shielded
- cable length: ~ 6 ft. (1.8 m)
- Weight w/o cable: ~ 12.3 oz. (349 g)
- Battery life: Up to 50 hours (2 AA batteries)
- Operating temperature: -20°C to +70°C
- Operating voltage: 11 - 30 VDC or 3VDC (2x AA)
- Dome type: ABS
- Characteristic SPL: ~95 dB SPL (1 kHz, 1 mW) @ maximum volume nominal
- Contact pressure: ~1.4 lb. (6.2 N)
- ENC peak attenuation: 30dB @ 150Hz
- ENC attenuation range: 20Hz―1KHz
- Total harmonic distortion (THD): < 1% - 110 dB SPL (300 - 3,000 Hz)
- Ear Transducer principle: Dynamic
- Ear Impedance: 150 Ω mono / 300 Ω stereo (each ear)
- Ear Freq Response: 12 - 15,000 Hz
- Microphone principle: pre-polarized condenser microphone (electret), noise cancelling
- Mic Impedance: 150Ω nominal
- Mic Sensitivity: 400mV+/-6dB into 150Ω load @ 1kHz for 114 dB SPL input
- Mic Freq Response: 150 - 8,000 Hz
- Mic DC Supply V.: 8-16V, not polarity sensitive
- Source Resistance: 470Ω
H10-13H Helicopter Headset
$343.00
H10-13X Electronic Noise Canceling Headset
$668.00
- Earphone Type: Dynamic(ENC)
- Noise-Canceling Mic: M-7A Amplified Electret
- Earphone Impedance: Monaural, 150 Ohms nominal, stereo, 300 Ohms nominal per side
- Mic Impedance: 50 ohms +/- 20%
- Earphone Sensitivity: 90 dB SPL on flat plate coupler, re 1mW input @ 1KHz
- Mic Sensitivity: 400mV RMS ±6dB into 150 ohm load @ 1kHz for 114dB SPL input
- Earphone Frequency Response: 100-5,500 Hz
- Mic Freq Response: 300Hz--3.5KHz per RTCA DO 214
- Earphone Plug: PJ-055 (.25" phone plug)
- Mic Plug: PJ-068 (.206" phone plug)
- Boom Type: Patented Flex/Wire
- Cord: 5 ft.Straight
- Headpad/Hardware: Super-Soft, Double-Foam Headpad,Lightweight Hardware
- Weight/Headset Only: 18 oz.
H10-13XP Electronic Noise Canceling Headset, Panel Powered
$721.00
- Earphone Type: Dynamic(ENC)
- Noise-Canceling Mic: M-7A Amplified Electret
- Earphone Impedance: Monaural, 150 Ohms nominal, stereo, 300 Ohms nominal per side
- Mic Impedance: 50 ohms +/- 20%
- Earphone Sensitivity: 90 dB SPL on flat plate coupler, re 1mW input @ 1KHz
- Mic Sensitivity: 400mV RMS ±6dB into 150 ohm load @ 1kHz for 114dB SPL input
- Earphone Frequency Response: 100-5,500 Hz
- Mic Freq Response: 300Hz--3.5KHz per RTCA DO 214
- Earphone Plug: PJ-055 (.25" phone plug)
- Mic Plug: PJ-068 (.206" phone plug)
- Boom Type: Patented Flex/Wire
- Cord: 5 ft.Straight
- Headpad/Hardware: Super-Soft, Double-Foam Headpad,Lightweight Hardware
- Weight/Headset Only: 18 oz.
